ARP Connecting Rod Bolt Kit - 17-24 Ford 6.7L Powerstroke

Product Name: ARP Connecting Rod Bolt Kit - 17-24 Ford 6.7L Powerstroke
Manufacturer: ARP
Manufacturer Part #: 250-6304
Thoroughbred Diesel Part #: ARP250-6304
Fitment Notes: 2017-2024 Ford 6.7L Powerstroke

Unquestionably the most important fasteners in any engine are the connecting rod bolts, as they hold the key to the entire rotating assembly. A broken bolt will lead to a catastrophic engine failure. As you can imagine, the most critical joint is where the connecting rod halves mate. The rod bolts must support the primary tension loads caused by each rotation (or cycle) of the crankshaft. When the crank rotates, the big end of the connecting rod essentially becomes oval-shaped and the rod bolts bend. As the crankshaft continues to rotate, the rod becomes round again. With alternating tension loads and cyclic bending of the bolts, it is very important to install fasteners that are able to exert a clamping force greater than the load imposed upon the join (tension).

In addition to utilizing a rod bolt with sufficient strength to withstand the tremendous cyclical strains placed upon it, it is absolutely imperative that the bolts be properly tightened. The preferred method of monitoring the correct amount of tension is through use of a stretch gauge. This is far more accurate than using a torque wrench. Moreover, through subsequently checking the rod bolts length at teardowns, it is possible to determine if it has been stressed beyond safe limits and must be replaced.

Each set of ARP Connecting Rod Bolts is manufactured from ARP's proprietary ARP 2000 material in their California manufacturing facility. Each stud has threads rolled after heat-treating to provide superior strength. The studs are centerless ground for perfect concentricity and each kit includes heat-treated, chromoly steel 12-point nuts and washers. ARP treats all of their harddware with a black odize finish for protection and durability. Get a set for your engine today!

ARP Connecting Rod Bolt Kit Features:

• Wave-Loc surface contacts the rod and cap for optimum alignment and reduction of fluctuating stress - which strengthens the rod itself!
• Provides snug fit for all OEM connecting rods (interference range of .001" to .005"), despite wide range of factory rod bolt hole tolerances.
• Superior material grain flow because of patented Wave-Loc surface design as compared to knurled bolts that have sharp edges and "built-in" stress risers.
• Galling and scoring of the rod is virtually eliminated because there is only smooth contact and absolutely no "digging."
• For more information on ARP call us at 1-859-737-4966